SMW SPACESAVER 2400S, Инструкция по установке, эксплуатации и обслуживанию

Страница: 56 / 86

Chapter 4 – Operation
4-30
SS2400T/S
4.10.3.4 #005 – CLAMPING DEVICE
Parameter #005 sets the logic of the open clamping device.
#005 Description
Standard
Clamping device is open, if the signal is ON. The clamping device is closed,
if the signal is OFF.
Inverse Clamping device is open, if the signal is OFF. Clamping device is closed, if
the signal is ON.
4.10.3.5 #006 – LANGUAGE
Parameter #006 sets the language of the barfeeder user interface. Change of the parameter
#006 is implemented immediately.
#006 Description
English The barfeeder communicates in English.
Czech
The barfeeder communicates in Czech.
4.10.3.6 #007 – K4 RELAY
Parameter #007 sets the meaning of the reserve relay of the K4 interface.
#007 Description
OFF K4 relay is inactive permanently.
TopCutInterlock TopCutInterlock signal is activated by trailing edge of the EOB M-code
or by leading edge of the Clamping Device Open signal, if the barfeeder
detects End of Bar. It is reset by the trailing edge of the second M-code
at the bar replacement.
This signal was used on older Mazak lathes, wherein it lock repeated
jump to a subprogram in End of Bar test (M69).
4.10.3.7 #008 – M-CODE STYLE
Parameter #008 sets for the method of signing the M-code off.
#008 Description
Dynamic Dynamic
M-code is such M-code, which can be deactivated by the lathe
independently of the barfeeder.
If
Dynamic
M-code is set in the barfeeder, the barfeeder always after the
end of the activity which started on M-code, sends the M-code end signal
long 0.5 s to the lathe. If the lathe is able to generate M-code only as a
pulse of a constant length and at the same time it is necessary that the
barfeeder reports the end of activity started by the M-code, it is necessary to
set #008 to
Dynamic .
Static Static
M-code is such M-code, which is sent by the lathe until it receives the
M-code end signal from the barfeeder.
If
Static M-code is set in the barfeeder, the barfeeder always after the end of
the activity which started on M-code, sends the M-code end signal only if
the lathe sends the M-code. However no longer than 0.5 s.
Overwhelming majority of new lathes use the static M-code. In this case it does not matter
from the functional point of view whether the parameter #008 is set to
Dynamic or Static
.
However if it was, for technological reasons, necessary for the lathe to send M-codes quickly
in succession (with a dwell less than 0.5 s) and the parameter #008 was set to
Dynamic
,