SMW SPACESAVER 2400S, Инструкция по установке, эксплуатации и обслуживанию

Страница: 29 / 86

Chapter 4 – Operation
SS2400T/S
4-3
4.4 BAR FEEDING
Bars are as a rule fed by the pusher into the lathe workspace. The lathe spindle must not
turn during feeding. If the parameter #011 is set to
Magazine Only (SS2400S), it is possible to
feed the bar using e.g. the second spindle of the lathe. In this case it is possible to feed the
bar without stopping the spindle. In all cases the bar must be centred by the spindle insert.
Feeding to stopper Feeding to position (SS2400S)
Fig.4.2 Bar Feeding
4.4.1 FEEDING TO STOPPER
In bar feeding to a preset stopper which is as a rule fixed in the lathe tool head, the barfeeder
always acts on the bar by a force which maximum value is set in the parameter #300.
4.4.2 FEEDING TO POSITION (SS2400S)
In bar feeding to a predefined position the barfeeder feeds the bar by the length set in the
parameter #105 (#106). During feeding no obstacle (lathe tool head) must be on the bar
travel! If the bar hits the obstacle, the barfeeder will push the bar with a maximum possible
force. In this case the pusher
∅
6 mm can be bent. In the Position feeding mode the
parameter #300 limits only the force which ejects the rest of the bar and pushes the new bar
into the lathe spindle.