SMW SPACESAVER 2400S, Инструкция по установке, эксплуатации и обслуживанию

Страница: 4 / 86

Safety Instructions
4
SS2400T/S
•
If the machine has been out of service for a longer time, check the machining program,
part clamping and setting of the barfeeder parameters before fully automatic operation of
the lathe with the barfeeder.
•
Do not remove or unlock safety guards during barfeeder operation.
•
Do not remove or add bars while the barfeeder is running.
•
Do not wear rings, bracelets, watches, too free clothing etc at work with the barfeeder.
Long hair should be protected by a suitable cap.
•
Do try to stop or slow down the barfeeder by your own hands.
•
Accessories, which were not delivered by the manufacturer within the basic shipment,
must be checked thoroughly by authorized personnel in installation.
•
Be especially careful close to unprotected moving parts, in particular in their initial setting.
Beware of sharp edges of parts.
•
Use only hammers with a soft head (if you must use the hammer).
•
Observe operating limits of the equipment given in the specification.
•
Use spindle insert to ensure correct position of the bar in the lather spindle.
•
Do not process the bars exceeding the length of the lathe spindle/spindle insert.
•
Make sure that the channel is empty before loading a bar from the table into the channel.
•
Always set the parameter #101 with a sufficient margin to eliminate contact of the pusher
with the rotating spindle
•
Set a minimum value of the parameter #300. Too high feeding force overloads both the
barfeeder and the lathe.
•
Before start of the work make sure that all safety circuits are active.
•
Check where all Stop and Total Stop pushbuttons are located.
•
Prior to activation of the automatic cycle make sure that all required functions are
properly set and that all controls are set to correct position.
Observe labour safety principles!!!