SMW SPACESAVER 2400S, Инструкция по установке, эксплуатации и обслуживанию

Страница: 54 / 86

Chapter 4 – Operation
4-28
SS2400T/S
Simulation mode activation
•
Change the user level to service level and set the parameter #000 to Simulation .
•
Put the barfeeder into the basic position the automatic cycle starts from. The pusher must
be in the low rear position.
•
Using select Automat mode.
•
Put the barfeeder in motion by pressing the key .
•
After simulation of the bar measurement by the barfeeder, start the testing program in
the lathe.
The Barfeeder now moves the pusher forward and back to simulate the bar feeding.
End of Bar simulation
If you want to simulate the End of Bar, press the key .
Now the barfeeder behaves in bar feeding in the same way as if there really were a short bar
in the lathe. Therefore it sends the End of Bar signal to the lathe, and simulates its
replacement by its motions. The program in the lathe goes to the block N200 and controls
the barfeeder during replacement of the bar.
4.10.3.1.3 TEST MODE
The
Test
mode is particularly used for the barfeeder running-in.
After start of this mode the barfeeder moves the pusher to the position saved in the
parameter #102. After it, it returns, lifts the pusher to the upper position, shifts the flag into
front position, returns the flag, moves the pusher to the lower limit position, and repeats the
whole cycle.
Attention!
In the Test mode the barfeeder can also work with the open cover (the
mode switch S3 can be in MAN position)!!!
Your inattention can cause your injury!!!
Test mode activation
•
Change the user level to service level and set the parameter #000 to
Test
.
•
Put the barfeeder into the basic position the automatic cycle starts from. The pusher must
be in the low rear position.
•
Using select the Test mode.
•
Put the barfeeder in motion by pressing the key .