SMW SPACESAVER 2400S, Инструкция по установке, эксплуатации и обслуживанию

Страница: 46 / 86

Chapter 4 – Operation
4-20
SS2400T/S
4.10.2.3 #300 – FEEDING FORCE
Parameter #300 sets forth a maximum force, by which the barfeeder will push the bar to the
stopper, eject the bar rest, slide the new bar in the spindle lathe, and go forward (toward the
lathe) in the manual mode.
Standard working range of the parameter #300 is 0 to 100%. Exceptionally the parameter
#300 can be set up to 167%.
Feeding force higher than 100% loads the barfeeder excessively, which can
result in frequent drive overload error messages.
Parameter #300 does not limit the feeding force in feeding without the
stopper. If the barfeeder is not able in
Position feeding to feed a bar to the
required measure (an obstacle in the bar travel), it exerts up to 167% force
on the bar irrespective of the value in the parameter #300.
4.10.2.4 #010 – PUSH MODE (SS2400S)
Parameter #010 sets forth the way of bar feeding into the lathe.
#010 Description
Stopper The barfeeder will feed the bar to the lathe stopper, on which it may exert by
the maximum force stored in the parameter #300.
Position The barfeeder will feed the bar to a set position (#105, #106, #107). In
feeding to Position it can apply up to 100% force on the bar independently
on setting of the parameter #300.
4.10.2.5 #105, #106 – FEEDING LENGTH (SS2400S)
Parameters #105 and #106 set the length, by which the barfeeder will move the bar in
feeding to
Position (#010). The feeding length is also used in case when the barfeeder works
in Magazine Mode (#011), irrespective of the value of the parameter #010.
The barfeeder differs between First Feeding Length (#106) and Second Feeding Length (#107),
which alternate as follows depending on the values entered in them.
#105 #106 Description
0 mm 0 mm The barfeeder always arrives to the bar position and there it
stops. The bar will always be "fed" by 0 mm.
30 mm 0 mm If #106=0, it is ignored. At each feeding the barfeeder feeds
the bar by 30 mm.
30 mm 30 mm At each feeding the barfeeder feeds the bar by 30 mm.
30 mm 50 mm At each odd feeding after the automat start-up or after the bar
replacement the barfeeder feeds the bar by 30 mm. At each
even feeding by 50 mm.
The driver controlling the feeding order is reset after the
automat start-up and after replacement of the bar. The new
bar will first always be fed by the
First Feeding Length .
0 mm 50 mm At each odd feeding the barfeeder only arrives to the bar
position. At each even feeding it feeds the bar by 50 mm.