smv MULTI-LIFT SYSTEM, Инструкция по эксплуатации

Страница: 35 / 53

35
RECEIVER MODEL RXVESNS-05-B/G
This unit is designed to be used for the control of solenoid valves which operate the hydraulic drives installed on motor
vehicles (market place vans, motorhomes, auto market, trailer motors with closure devices for awnings etc) or on
applications that use battery power.
This receiver is used with
MOD. TXB/TXG remote controls.
The unit is equipped with a main power switch. If the unit is installed in a place that is not easily accessible, a section
2x2.5 mm
2
cable, to which a supplementary switch to turn on/off the device at a distance, can be connected to the J3
connector.
On request, it is possible to carry out customized pad printing of the controls on the unit.
The unit is covered by a 24-month guarantee from its manufacturing date, if installed and used according to the
instructions below.
INSTALLATION PROCEDURE
1) Remove the nylon screws from the unit cover to which the control circuit is fixed. Fix the base of the waterproof
holder, using screws, inside the vehicle according to the reference positions. Lay out the connection cable from the
«solenoid valve block» to the fixing point of the waterproof case. Insert the cable into the cable gland supplied for
approximately 20 cm, then tighten the cable gland.
2) Connect the numbered cables to the J1 terminal board.
Connections to
Connections to
J1 (18 pins) terminal board J2 (8 pins) terminal board
TERMINAL
NUMBER
Cable
no.
Connections Terminal
no.
Cable
no.
Connections Terminal
no.
Cable no. Connections
1 10 1 5 EV 5
2 11 9 PUMP 2 6 EV 6
3 1 EV 1 12 10 EARTH (-) 3 7 EV 7
4 2 EV 2 13 11 EARTH (-) 4 8 EV 8
5 3 EV 3 14 12 5
6 4 EV 4 15 13 6
7 16 14 BATTERY
+12/24 V
7
8 17 15 BATTERY
+12/24 V
8
9 18