smv MULTI-LIFT SYSTEM, Инструкция по эксплуатации

Страница: 17 / 53

17
PROCEDURAL STANDARDS FOR CORRECT INSTALLATION
FILLING TANK
If the power pack is supplied with the tank, fill it with hydraulic oil filtered during racking to a filtration value of 25
micron or lower and check the level using the level rod located on the filling cap or by using the visual level, if present.
If the power pack is not equipped with a tank, install the collector in its dedicated space checking that the collector ring
on the connection interface is tight enough; then fill as indicated above.
ELECTRICAL CONNECTION
Read the hydraulic diagram and the electrical diagram, if provided
(for further information please contact our technical department);
Check that the dimensions of the electrical system are suitable for the electrical input of the various uses (motor-valves-
electrical panel-relay-etc.).
When first starting up the motor, check that the pump rotates in the correct direction. Check that the motor voltage and
the electrical components respond to conformity requirements.
ROTATION DIRECTION
In the case of direct current motors, the rotation direction is established by the manufacturer during the assembly phase.
In our case, the rotation direction needs to be verified.
CONNECTING UP WORKING PARTS
Avoid, at all times, the removal of plastic caps that act as protection for the outlets until the electrical current cables are
connected.
Connect the cables making sure that the entire operation is carried out in conditions of complete cleanliness: we remind
you that starting up fittings with dents on the male thread causes chipping in the seat and is the main cause of
solenoid
valve blockages or leakages of the check valves .
Moreover, we advise you to carefully check the cleanliness of all tubes (both rigid and flexible) and of the various
working parts (jacks, hydraulic motors).

Warning
DURING INSTALLATION, CLEANLINESS IS THE MAIN ASSURANCE FOR THE GOOD WORKING
ORDER OF YOUR HYDRAULIC SYSTEM.