smv MULTI-LIFT SYSTEM, Инструкция по эксплуатации

Страница: 7 / 53

7
THE SYSTEM INCLUDES
4 hydraulic jacks
1 hydraulic power pack
1 emergency pump
1 electronic control panel
1 remote control
1 black box for control of jacks
4 integrated check valves
4 mechanical limit switches
1 tube and tube fittings kit
Different attachment points and fixing systems are used according to the type of chassis.
CHASSIS: IVECO ISUZU DUCATO MERCEDES FORD RENAULT MAN etc.
The system is removeable at any time and can be reused on a new vehicle. The weight of the system does not modify
the weight distribution on the axles and does not influence the driving trim.
As a rule of thumb, the weight varies according to the type of model from a minimum of 60 kg to a maximum of 85 kg.
Once the vehicle is in the right position pull on the handbrake and switch off the engine .
In the case of AL-KO chassis, it is only necessary to put the vehicle into gear without pulling on the handbrake
to avoid the vehicle moving forward when the system is functioning.
Ensure that there are no persons, obstacles and/or animals under the camper van and that the terrain is compact.
Do not use the system close to the roadside, near precipices or on crumbly or steep slopes. In the correct position and
with the control panel switched to ON we can start stabilizing by lowering the hydraulic feet.

Warning
ALL 4 FEET MUST ALWAYS BE DOWN IN ORDER TO STABILIZE THE VEHICLE WITH THE TYRES
PLACED FIRMLY ON THE GROUND.
The system stabilizes and levels by operating 2 stabilizers at the same time, providing 2 support points and easy
levelling reference.
The 2 front, 2 back and 2 side cylinders on the right and left hand sides and all cylinders in the exit phase and entry
phase can be operated using the remote control. Only use single control buttons in the event of an emergency.
With the fixed control panel it is possible to operate 1/2 feet at a time lifting or lowering the corresponding switch.
The small panel “black box” comprising 1 yellow led, 1 red led for mechanical limit switches and 2 acoustic sounds
will inform you continuously on the functioning of the system.
The red and yellow leds on the fixed control panel check the position of each jack.
Operating the system with the vehicle ignition key and engine switched off.