smv MULTI-LIFT SYSTEM, Инструкция по эксплуатации

Страница: 10 / 53

10
REPLACING THE REMOTE CONTROL BATTERIES
MODELS TXE-B (434,42 MHZ) TXE-G (433,42)
•
Remove the screw at the back of the remote control using a philips screwdriver .
•
Lift the printed circuit out by gently pushing the screwdriver inside the hole.
•
Remove the two batteries.
•
Insert 2 new lithium CR 2032 (3 volt) batteries, one at a time, with polarity end ( +) upwards.
•
Press any button to check if the red LED light flashes.
•
If the red transmission LED light does not flash, remove the replacement batteries and reinsert them, then
press any button to see if the LED flashes.
•
If the LED flashes, close the remote control transmitter following the above steps in reverse order.
PLEASE NOTE: the remote control with the receiver switched to ON is programmed to function for a pre-set time, at
the end of which it switches itself off automatically. To turn it on again it must be reset by pressing the ON/OFF
receiver.
A B C
D E F
G H I
L M N
Press this button only to change
combination