Smiths detection HI-SCAN 100100T, Руководство пользователя

Страница: 61 / 222

How to carry out inspections

When electronically marked items leave the inspection
tunnel, an audible signal is triggered. This function will
help you or your colleague to separate the suspect
item from the non-suspect items on the tunnel exit side.

If the X-ray inspection unit is not equipped with a sep-
arate recheck station*, the baggage or freight item
should be rechecked manually at a place where you
can have a look at the X-ray unit's monitor. To facilitate
the recheck, you can recall the corresponding X-ray
image on the monitor with the
REVIEW function
(
3
and
2
) (see above).
Send X-ray image to recheck station(s)*
If one or more recheck station(s)* is/are connected to the
HI-SCAN unit, pressing
H
to mark the suspect baggage
or freight item electronically (audible signal, see above)
will,
simultaneously , lead to the transfer of the corres-
ponding X-ray image to a free recheck station.
If the image cannot be transmitted to any recheck station, since all of them are occupied, a respective error
message (
F
1-95) will appear.

Use
r
to repeat the transmission in case of error.
Send X-ray image to Central Image Data Archive CIDA*
If the HI-SCAN unit is connected to a C entral I mage D ata A rchive* (CIDA) via a data network*, the suspect
baggage or freight item will not only be marked with
H
for being audibly identified (see above) but at the
same time, the corresponding X-ray image will be transferred to the image data archive.
Particularities of units equipped with the Xport image transfer system*
If the Xport image transfer system is set to automatic transfer all X-ray images will be converted by means of
the Xport image transfer system and then transferred either via a data network* to the Xport target com-
puter* or to a USB memory* that is connected to the X-ray unit as soon as the corresponding baggage or
freight items have been completely scanned.

If the automatic transfer is switched off* (with newer software) you can transfer single X-ray images by
pressing the priority key assigned to the
TRANSFER IMAGE* function.
95587412 01/01/09 © Smiths Heimann
1-51
I
You can set the time the audible signal is
sounded (
F
1-91).
A
Warning!
When rechecking suspect objects, pro-
ceed according to the
provisions and
safety instructions given to you! 980
I
A recheck station can store up to 3 X-ray
images . Further images cannot be
transferred until the previously trans-
ferred images have been evaluated by
the operators at the stations.
S
Attention!
If you cancel the transmission with
s
, the image will be deleted and
cannot be used for the recheck! 990