Smiths detection HI-SCAN 100100T, Руководство пользователя

Страница: 105 / 222

How to correct operating troubles
No test image/wait indicator does not light up or flashes
Cause Correction
Defect in electronics.

The correction of the defect must be carried out
by a competent service technician.
No or insufficient test image/wait indicator lights up briefly after switching
on
Cause Correction
The screen saver is active.

Press any key.
The monitor mains cable is not correctly plugged in,
or the monitor is switched off (power indicator of
monitor does not light up).

Check mains switch and mains cable of the mon-
itor as far as it is accessible.
Monitor is not adjusted correctly.

Check monitor adjustment (see enclosed operat-
ing instruction of the monitor).
Video cable is not correctly plugged in.

Check plug as far as it is accessible.
Error messages
Most of the messages can be deleted with
r
before
following the instructions to correct the error.
All error messages are collected in the
Error report
(
F
1-93) so that you can have a look at the messages
again after deletion.
Error messages with error code
Error messages Cause/Correction
Error code: 0009
X-ray system defective or operating conditions out of
range!

On units equipped with a heating or cooling sys-
tem* for the X-ray generator, the correct operat-
ing conditions will be automatically established
after a short time.
95587412 01/01/09 © Smiths Heimann
1-95
I
If the error message is not contained in
the following list, and if it appears again
and again even after switching off and on
the HI-SCAN X-ray unit, you should ask
your local service office or Smiths Hei-
mann to do the repair. Please indicate
the
Error code in such case.