-27-
6.3 Handling
Warning
1. If abnormal heating, smoking or fire, etc., occurs in the product, immediately shut off the
power supply.
2. Immediately stop operation if abnormal operation noise or vibration occurs.
If abnormal operation noise or vibration occurs, the product may have been mounted incorrectly.
Unless operation of the product is stopped for inspection, the product can be seriously damaged.
3. Never touch the rotating part of the motor or moving part of the actuator while in operation.
Alterations made to this product may lead to a loss of durability and damage to the product, which can
lead to human injury and damage to other equipment and machinery.
4. When installing, adjusting, inspecting or performing maintenance on the product, driver and
related equipment, be sure to shut off the power supply to them.
Then, lock it so that no one other than the person working can turn the power on, or implement
measures such as a safety plug.
Caution
1. Keep the driver and product combined as delivered for use.
The product is set in parameters for shipment. If it is combined with a different parameter, failure can result.
2. Check the product for the following points before operation.
a) Damage to power supply line and signal line.
b) Looseness of the connector to each power line and signal line.
c) Looseness of the actuator /cylinder and Driver /driver mounting
d) Abnormal operation
e) Emergency stop of the total system
3. When more than one person is performing work, decide on the procedures, signals, measures
and resolution for abnormal conditions before beginning the work. Also, designate a person to
supervise work other than those performing work.
4. Actual speed of the product will be changed by the workload.
Before selecting a product, check the catalog for the instructions regarding selection and
specifications.
5. Do not apply a load, impact or resistance in addition to a transferred load during return to
origin.
In the case of the return to origin by pushing force, additional force will cause displacement of the
origin position since it is based on detected motor torque.
6. Do not remove the nameplate.
7. Operation test should be done by low speed. Start operation by predefined speed after
confirming there is no trouble.
8. Do not apply impact/collision/resistance for mover of actuator in operation.
It will cause decrease of product’s life, damage to product, and so on
[Ground]
Warning
1. Do the earth construction surely.
2. Refer to the driver manual for the grounding procedure and notes.
[Unpackaging]
Caution
1. Check the received product is as ordered
If the different product is installed from the one ordered, injury or damage can result.