- 6 –
No.JXC
※
-OMY0002
2.
Product Outline
2.1 Product features
The followings are the main functions of this controller:
Electric Actuator Control
Positioning operation and Pushing operation, at a specific speed and force, of the electric actuator
are possible by controlling the Step motor (24 VDC servo).
Specified force operation
Control the pushing force (or the pressing force) of the electric actuator.
Return to origin
Return the electric actuator to the home position by sending a single signal to a dedicated terminal.
Alarm detection function
Automatically detect the abnormal conditions and output the appropriate alarm signal via the serial
interface and parallel I/O. The alarm information (up to the last 8 alarms) will be recorded into the
memory in the controller.
64 step data
Control the electric actuator according to the step data specified by the input of parallel I/O.
It is possible to setup various parameters for each operation pattern.
Area output
The area output terminal will be activated if the electric actuator position is within the range specified
by "Area 1" and "Area 2" in the step data.
Data input method
It is possible to perform parameter setup, status monitoring, trial run and alarm reset via the serial
communication with a PC installed with the controller setting software or the teaching box.
Easy mode and Normal mode
There are two available modes for the controller setting software and the teaching box. In Easy mode,
you can start the operation by only setting the speed, position, etc. In Normal mode, further detailed
setup can be performed.
High performance type
The cycle time of the device is improved by increasing the maximum acceleration speed and maximum
speed.
Caution
Please keep this manual safe for future use. It will be necessary to refer to this manual along with the
operation manuals for other electric actuators, teaching box, and controller setting software at installation
and fault finding.
Keep this operation manual accessible for reference.