SMC Networks HRS012-W, Руководство по эксплуатации

Страница: 16 / 82

HRX-OM-M091
Chapter 2 Contact input/output communication
2.4 Setting and checking HRS Series
2-6
Contact input signal1 Setting and checking
3.
Display the screen of contact input signal 1 by pressing the [SEL] key several times.
The set screen of contact input signal 1 is displayed on the digital display.
PV
SV
4.
Select contact input signal 1 from the table below with [ ▲ ] key or [ ▼ ] key, and confirm by
pressing “SEL”.
Table 2.4-3 List of set values
Set values Explanation
Initial value
(Default setting)
Without input signal
Input of run/Stop signal
○
External switch signal input(N.O. type)
∗
3,
∗
4
External switch signal input (N.C. type)
∗
3,
∗
4
∗
3
：
When the setting of the communication mode is “DIO mode”, “External switch signal”
cannot be set.
∗
4 ： When the setting of the communication mode is “SEIRAL mode” and the protocol
setting is “Simplified communication protocol 2”, “External switch signal” cannot be
set.
Contact input signal 1 type Setting and checking
5.
Press the [SEL] key once.
The set screen of contact input signal 1 type is displayed on the digital display.
PV
SV
6.
Select contact input signal 1 type from the table below with [ ▲ ] key or [ ▼ ] key, and confirm
by pressing “SEL”.
Table 2.4-4 List of set values
Set values Explanation
Initial value
(Default setting)
Setting/checking are not available if the
setting of contact input signal 1 is OFF.
Alternate signal
○
Momentary signal
Momentary signal
∗ 5
∗
5
：
Used when the setting of the contact input 1 is “Operation stop signal input”.