SKYZER TECHNOLOGIES
PAGE 23 OF 81
INGENICO 5100 ANZ VERSION 4.8 OPERATING GUIDE
Version 1.1
At the
COMMS MODE,
press the corresponding
number key to select
preferred comms mode
and press
ENTER
1-Dial-up (page 20)
2-TCP-IP/Dial (page 21)
3-TCP-IP (page 22)
Refer to the page
number to configure the
terminal for selected
comms mode and
start
at comms mode prompt
in flowchart.
4.1.5
Multi Merchant Configuration Flowchart
From the idle screen
press
FUNC
and
then key in
7418
followed by the
ENTER
Key in the required
number of active
merchants and press
ENTER. Example: to
activate 3 merchants,
key in 123
From the
MULTI
MERCHANT SETUP
screen, press
3
to set up
required number of
active merchants.
START
Press
ENTER
at the
CONFIG PARAMS?
Terminal will display
activated merchants.
1 Merchant 1
2 Merchant 2
3 Merchant 3
Press the
corresponding
number key followed
by the
ENTER
to select
for terminal
configuration.
Press
FUNC 3824
to
configure active
merchants.
Each merchant must
be configured
individually.
Key in the Terminal ID
and press
ENTER.
Network Interface
Identifier
(NII)
is set by
default as
030
. Press
ENTER
Terminal will return to
MULTI MERCHANT SETUP
screen, press
CANCEL
to
exit.
Repeat steps until all
merchants have been
configured.
Press the
ENTER
key to
scroll through the
menu until
SUPERVISOR
is
displayed on the
screen.
Press
SAV
key to select
INIT
, to perform a
merchant logon.
Select
ALL MERCHANTS
to initiate logon for all
active merchants at
once.
NOTE:
If 8
merchants are
activated, then each
merchant will need to
be logged on
individually.
COMPLETED
