Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by
ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by
ŠKODA AUTO A. S.
�
– Insert a small cross-head screwdriver through the opening
-arrow A- and unlock the bottom catch peg.
– Press the top catch pegs -arrows B- and push the combination
switch -1- out of the bearing on the steering lock -arrows C-.
Kostal manufacturer:
– Screw out the screw -arrow- (1 Nm) and push the combination
switch -1- out of the bracket on the steering lock.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
– Make sure that all the retaining lugs and plug connections lock
in place correctly.
7.2.4
Contact assignment on the steering col‐
umn electronics control unit - J527-
You can find the current contact assignment in the ⇒ Current flow
diagrams, Electrical fault finding and Fitting locations.
7.3
Setting middle position of the return ring
with coil spring
It is only carried out if there is a doubt about the correct setting of
the centre position for the return ring rotor.
Work procedure
– Put the front wheels in straight ahead position.
– Slowly turn the ring rotor manually to the right up to the stop.
– Slowly turn the ring rotor manually to the left up to the stop and
count the number of turns.
– Slowly turn the ring rotor to the right by half of the counted
turns in the centre position (top connector must be in horizontal
position).
– Install steering wheel ⇒ Body Work; Rep. gr. 69 , if necessary
lock ring rotor with transport security or adhesive tape.
Octavia II 2004 ➤ , Octavia II 2010 ➤
Electrical system - Edition 12.2013
144
Rep. gr.94 - Lights, bulbs, switches - exterior
