Sirona Heliodent plus, Руководство по установке

Страница: 28 / 76

62 14 972 D 3507
28 D 3507
.
031.01.07
.
02 11.2010
Installation Sirona Dental Systems GmbH
Installing the manual release holder Installation Instructions HELIODENT
PLUS
5.5.2 Installation on the cover (wall module)
empty
Scope
For installation option: 1
empty
Installation
1. If the protective cover is already attached, remove it from the wall
adapter.
2. Mark the drill hole (see drawing).
3. Center punch the mark.
4. Drill a 4.3 mm (3/16") hole at the mark.
5. Pull off the protective foil of the two-sided adhesive tape at the holder.
6. Adhere the holder to the front of the protective cover to match the
drilled hole (watch for top/bottom alignment).
7. Fasten the holder tight. Use the supplied (M4x16) screw, washer and
nut for this purpose.
CAUTION
Important installation instructions
- Do not drill holes in the protective cover when it is attached! The
protective cover must be removed.
- Only the specified positions may be drilled (Tolerance: ±1cm (3/8“)).
- Use only the supplied screw. Otherwise there is a hazard due to live
parts.
NOTICE
Different installation heights
Note that the installation heights vary according to the desired
installation position (right/left).
50 mm (2”)
80 mm (3 1/8”)
100 mm (4”)
50 mm (2”)