SINO SDS6, Руководство по эксплуатации

Страница: 28 / 117

B. Smooth R(Be the same with: MIIL_MS
、
MIIL_M)
19
7. Enter the start angle of the circular arc (ST ANG)
This determines the position of the first cut feed in the processing of circular arc.
As show in Fig.(b), the start angle is 0° if the arc is to be processed from Point E
to Point F, and 90° when from F to E.
8. Enter the end angle of the arc (ED ANG)
This determines the position of the last cut feed in the processing of circular arc.
As shown in Fig. (b), the end angle is 90° if the arc is to be processed from Point E
to Point F, but 0 when from F to E.
9. Determine inner/outer circle mode:
For outer circular arc, as shown in Fig. (b), RAD+TL.
For inner circular arc, as shown in Fig. (c), RAD -TL.
10. Move the machine tool to the start point of the processing in
following with the display on axes, and then start the point by point
processing.
11. You can quit the Arc R Calculation function as will, just key .
(
Ⅰ
) *Take the processing of the arc shown in the figure in page 22 as an
example.
1) At first, finish tool setting, reset, key ,
and enter ARC function.
2)choose smooth function
press
press
（
only 2V readout has this set item and 3V readout has only smooth R function
，
so hasn’t the set item and directly get into next step
）
3) Select processing plane
Key or
4) Select Plane XY
Key
5) Enter the position of the circle center.
If finish the tool setting as shown in Fig. (a).
Key
R
R
2 4
5 SEL
SEL