Simex PL 4520, Руководство по эксплуатации и обслуживанию

Страница: 51 / 60

51
The jack (fig. 2, previous page) that controls the tilt, is activated using a combination of the control located on
the panel in figure 3 and the control located in the prime mover (the second auxiliary device control, not the
high flow control).
For the machines featuring 5 hydraulic lines:
- keep switch B pushed in the direction shown by the
arrow in fig. 3 and, at the same time, operate the
control in the prime mover to open the or close the
jack (fig. 2). Set the desired tilt angle (max 8° to the
right or left), referring to the sticker in fig. 7 para.
9.10 to check the tilt degree.
16.5 Hydraulic depth adjustment
There is a hydraulic planing depth adjustment feature available on request, which operates using the jacks
shown in fig. 3 on the following page.
The jacks (fig. 3, next page) are operated using the controls on the panel in figure 1:
For the machines featuring 3 hydraulic lines.
- deactivate the drum by flipping the switch (ref. “A”
in fig. “1) to OFF and check that the red LED is off
(ref. “B” in the figure);
- turn selector dial C to the right-hand jack depth
adjustment symbol (“R”), as shown in fig. 1, or to
the symbol for the left-hand jack (“L”);
- switch on the oil pressure using the controls on the
prime mover;
- flip switch D to the right or the left to open or close
the jack selected and set the desired depth. Refer
to the stickers on the jacks for the depth value you
wish to set.