A N 5 4 3
28
Rev. 0.9
Command 0x13 SET_PROPERTY
The SET_PROPERTY command sets the value of a property. The CTS bit (and optional interrupt) is set when it is
safe to send the next command. This command may only be sent in powerup mode.
Command
Response
Bit
7
6
5
4
3
2
1
0
CMD
0x13
ARG1
00000000
ARG2
PROPH[7:0]
ARG3
PROPL[7:0]
ARG4
PROPDH[7:0]
ARG5
PROPDL[7:0]
ARG
Bit
Name
Function
1
7:0
Reserved
Always write to 0.
2
7:0
PROPH
[7:0]
Property Address High Byte
This byte, in combination with PROPL, is used to specify the property to modify.
3
7:0
PROPL
[7:0]
Property Address Low Byte
This byte, in combination with PROPH, is used to specify the property to modify.
4
7:4
PROPDH
[7:0]
Property Data High Byte
This byte, in combination with PROPDL, is used to set the property value.
5
7:0
PROPDL
[7:0]
Property Data Low Byte
This byte, in combination with PROPDH, is used to set the property value.
Bit
7
6
5
4
3
2
1
0
STATUS
CTS
ERR
XX
RSQINT
RDSINT
ACFINT
STCINT
Note:
The above response shows status bits for FM Receive mode (see Table 8 on page 20). See Table 9 on page 21 for
status bits for AM Receive mode.
