Siemens SINAMICS G180, Инструкция по установке и эксплуатации

Страница: 61 / 218

Description
3.3 Accessories
Installation and Operating Instructions SINAMICS G180
Operating Instructions, 02/2019, 4BS0751-007
59
Note
Suitable fiber types
HCS as well as APF cables (POF) are suitable for connecting to the fiber optic sockets.
Typical cable lengths are up to 100 m (HCS) or up to 50 m (POF).
Table 3- 5 PROFINET board - external elements
Component Function
NS
"Network status"
display
Off Offline No power supply or no connection with
the IO controller
Green, lit Online (status:
RUN)
Connection established with the IO
controller, IO controller in the RUN
state
Flashing green
(1 Hz)
Online (status:
STOP)
Connection established with the IO
controller, IO controller in the STOP
state or IO data error
Green flashing (3x
at 1 Hz)
Flashing Flashes three times in order to identify
the slave in the network.
Red, lit Fatal event Fatal, internal error.
This display occurs in conjunction with
a red "Module status" LED.
Flashing red
(1 Hz)
Error, station
name
A station name has not been assigned
(factory setting).
Flashing red
(2 Hz)
Error, IP address An IP address has not been assigned
(factory setting).
Flashing red
(3 Hz)
Error, configura-
tion
The reference configuration (expected
identification) differs from the actual
configuration (real identification) of the
system.
MS
"Module status"
display
Off Not initialized No power supply voltage or module in
the SETUP or NW_INIT state
Green, lit Normal operating
sequence
The module has exited the NW_INIT
state.
Flashing green
(1 Hz)
Diagnostic
event(s)
At least one diagnostics event is active.
Red, lit Exception error Device in the EXCEPTION state
Fatal event Fatal internal event.
This display occurs in conjunction with
a red "Network status" LED.
Flashes red/green
alternating
Firmware update Do not switch off the module.
Switching off the module during the
update can result in permanent dam-
age.