Siemens RUGGEDCOM WiN5100, Руководство пользователя, Страница: 13 / 114

RUGGEDCOM WiN5100/WiN5200
User Guide
Chapter 2
Product Description
IEEE 802.16e Mobile WiMAX Compliance 5
Product Description
The WiN5100-series and WiN5200-series Out Door Unit (ODU) Customer Premises Equipment (CPE) units are
IEEE 802.16-2005 compliant wireless devices for the deployment of point-to-multipoint (PMP) and point-to-point
(PTP) network architectures.
The ODU CPEs are WiMAX Forum 802.16e Wave 2 (MIMO) certified subscribers. Each subscriber registers and
establishes a bi-directional data link with the base station.
NOTE
This device complies with Industry Canada license-exempt RSS standard. Operation is subject to the
following two conditions:
• this device may not cause interference, and
• this device must accept any interference, including interference that may cause undesired operation
of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
• l'appareil ne doit pas produire de brouillage, et
• l'utilisateur de l'appareil doit accepter tout brouillage radio électrique subi, meme si le brouillage est
susceptible d'en compromettre le fonctionnement.
Section 2.1
IEEE 802.16e Mobile WiMAX Compliance
The IEEE 802.16-2005 specifications describe a PMP broadband wireless access standard for systems. This
standard includes descriptions for both the Media Access Control (MAC) and the physical (PHY) layers.
The ODU CPE is compliant to IEEE 802.16-2005 WiMAX forum Wave 2 profile.
NOTE
The 802.16e standards are subject to amendment and the WiN5100/WiN5200 product family design
compliance applies to a specific revision of the standard. The WiN5100/WiN5200 product family does
not support mesh communication (direct subscriber-to-subscriber).
Section 2.2
Block Diagram
The CPE consists of the following modules:
1.
Base-Band board: includes the the WiMAX 16e MIMO Base-Band SoC and runs the 16e MAC + PHY, user
interface, and analog front end interface to the RF module.
2. Power Supply board with DC/DC power supply: converts 48 VDC input to the voltages feeding the Digital
and RF modules.