Siemens 6GA7202-2AA10-1BF1, Руководство по эксплуатации, Страница: 72 / 168

program name "Modified" indicates which program was open and modified when the
connection was interrupted.
You may wish to save these changes immediately, since the changes will be lost if the connection
is terminated again or the program is changed.
Table 8-7 Program steps & program-specific toolbar
②
Button Description
Program Click this button to go to the "Program" program step.
Image acquisition Click this button to go to the "Image acquisition" program step.
CenSOR Click this button to go to the "CenSOR" program step.
Note
Change the camera to processing mode on completion of parameterization
On completion of parameterization, the camera needs to be changed to processing mode.
Only then does the cyclic processing of the acquired reflector images and communication with
the controller start.
Description of the page layout with three columns
Table 8-8 Page layouts
Column Description
Right-hand column
Image and result views
③
The settings for the image and result views are shown in this column. If the camera is in
processing mode ("Start"), the additional results are displayed.
Middle column
Display of image and results
④
This column shows the image that was acquired last or the current image as well as the
associated results
Left-hand column
Parameter area
⑤
The various parameters are shown in this column.
Parameterization
8.2 Application
SIMOCRANE CenSOR
70
Operating Instructions, 07/2021