Sibata 090860-0341, Руководство по эксплуатации

Страница: 25 / 44

- 23 -
Pressing the UP key switches the screen cyclically as follows: sampling start date → sampling start
time → sampling end conditions (3 conditions settable: duration, time and volume, each with a
different screen) → number of remaining cycles → flow rate setting. Pressing the DOWN key
switches the screen in the reverse direction.
The integrated flow volume and other setup items are sometimes displayed by using the UP/DOWN
key. (See page 26 "After Ending Operation.")
Pressing the MODE key in any of the screens changes the mode to memory.
The cycle timer mode can be set only on the PC. So, holding down the MODE key will not change
the screen to the setup screen.
Pressing the START/STOP key starts pump operation in the cycle
timer mode.
The operation display LED flashes (orange), the "timer standing by"
icon is displayed on screen, and the remaining sampling start time is
displayed.
* "WAIT" starts flashing when the remaining time counts down to two
minutes. If the START/STOP key is pressed to cancel pump
operation in this state ("WAIT" flashing), this cycle is not performed
and operation moves to the next cycle.
Pressing the UP key switches the screen cyclically as shown above: flow rate setting → sampling
start date → sampling start time → sampling end conditions (3 conditions settable: duration, time
and volume, each with a different screen) → number of remaining cycles → remaining sampling
start time. Pressing the DOWN key switches the screen in the reverse direction.
Flow rate setting
End integrated flow
volume (volume timer)
Sampling start date
Sampling start time
Sampling end date
Sampling end time
Sampling time
Number of remaining cycles
Note that cycle
operation can start
only from this screen!!