-
9
-
Instructions for Use
Installation Procedure
Install this equipment at a flat, stable location. To prevent it from overturning, be sure to
fasten it by staking the legs of the stand to the floor.
There are four anchor bolt holes in the bottom of the stand, and eight rope fastening
holes in the stand support column.
After installing the stand, place the sampler unit on it.
Lock the grips on the twist fasteners on the left and right sides of the main unit, fastening
the main unit to the stand.
Check that the twist fastener grip is raised (perpendicular to the front).
As shown in the figures, place the catch into the hook, and then rotate the grip 180
degrees. The fastener will now be hooked, so lower the grip.
Note: The eye bolts in the main unit top are used when fastening the air inlet port with
ropes. Never use these to fasten the main unit.
Note: Do not transport the equipment when the main unit is attached to the stand. This
is dangerous, as there is a risk that the grips will be damaged.
Rope fastening holes
Anchor bolt holes
Check that
the grip is raised.
The catch fits into the hook.
