DO. NOT. exceed.
1
⁄
8
". depth. of. cut. per.
pass. on. this. machine. or. kickback. and.
serious.injury.may.occur!
Figure.20.
Location of depth-of-cut
controls.
Figure.21.
Location of depth-of-cut scale.
-22-
Model W1876 (For Machines Mfd. Since 7/20)
O
PE
R
ATIO
NS
Setting.Depth.of.Cut
The depth of cut on a jointer affects the amount of
material removed from the bottom of the workpiece as it
passes over the cutterhead.
Depth of cut is set by adjusting the height of the infeed
table relative to the outfeed table, and cutterhead inserts
at top dead center (TDC).
Adjusting.Infeed.Table.Height
To adjust infeed table height, loosen table height
lock knob, rotate infeed table adjustment knob
counterclockwise to raise table, or clockwise to lower
table, and then tighten table height lock knob to secure
setting (see
Figure.20
).
Depth-of-Cut.Scale
Depth of cut can be referenced directly from the scale
located on front of jointer (see
Figure.21
).
Table Height
Lock Knob
Infeed Table
Adjustment Knob
Depth-of-Cut
Scale
Содержание W1876
Страница 52: ......
