Shop fox W1876, Руководство пользователя

Страница: 22 / 52

To. reduce. your. risk. of. serious. injury.
or. damage. to. the. machine,. read. this.
entire.manual.BEFORE.using.machine.
To. reduce. the. risk. of. eye. injury. and.
long-term. respiratory. damage,. always.
wear. safety. glasses. and. a. respirator.
while.operating.this.machine.
If you are an inexperienced operator,
we strongly recommend that you read
books or trade articles, or seek training
from an experienced operator of this
type of machinery before performing
unfamiliar operations. Above.all,.safety.
must.come.first!
This machine will perform many types of operations
that are beyond the scope of this manual. Many of these
operations can be dangerous or deadly if performed
incorrectly.
The instructions in this section are written with the
understanding that the operator has the necessary
knowledge and skills to operate this machine. If at any
time you are experiencing difficulties performing any
operation, stop using the machine!
The overview below provides the novice machine operator
with a basic understanding of how the machine is used
during operation, so the machine controls/components
discussed later in this manual are easier to understand.
Due to its generic nature, this overview is
NOT
intended
to be an instructional guide.
-20-
Model W1876 (For Machines Mfd. Since 7/20)
O
PE
R
ATIO
NS
OPERATIONS
General
To.complete.a.typical.operation.with.the.jointer,.the.
operator.does.the.following:
1.
Examines workpiece to verify it is safe and suitable
for jointing.
2. Adjusts fence for width of workpiece and locks it in
place.
3.
Adjusts fence tilt, if necessary.
4.
Adjusts infeed table height to set depth of cut per
pass.
5. Ensures cutterhead guard position and operation are
functioning properly.
6.
Puts on safety glasses, respirator, and any other
required protective equipment.
7. Starts jointer.
8. Using push blocks as needed, holds workpiece firmly
against infeed table and fence, and feeds workpiece
into cutterhead at a steady and controlled rate until
entire length of workpiece has been cut and it clears
the cutterhead on the outfeed table side.
9.
Repeats cutting process described
above until desired results are
achieved.
10.
Stops jointer.