Shop fox W1876, Руководство пользователя

Страница: 39 / 52

Figure.40.
Adjusting 90º fence angle.
Figure.39.
Example of checking 90º fence
angle with combination square.
-37-
Model W1876 (For Machines Mfd. Since 7/20)
SE
RV
IC
E
The fence has adjustable positive stops at the 90º and 45º
outward (135º) positions for quickly and accurately setting
the desired fence angle.
Note: To ensure accurate results when jointing, check
the accuracy of these settings frequently (monthly at a
minimum) and adjust them if necessary.
Item(s).Needed. Qty
Hex Wrench 2.5mm .............................................1
Combination Square ............................................1
To.check/adjust.fence.positive.stops,.do.these.steps:
1.
DISCONNECT MACHINE FROM POWER!
2.
Loosen fence slide lock handle and slide fence to
desired position, then tighten handle.
3. Loosen fence tilt lock handle and adjust fence to 90º
position, then tighten handle.
Note:
Both lock handles can be repositioned by
pulling up on the handle and sliding the square nut
underneath to the desired position.
4.
Place combination square on jointer table with 90º
side against fence (see Figure.39 ).
— If fence is flush against combination square, 90º
fence positive stop is set correctly. Proceed to
Step.6 .
— If fence is not flush against combination square,
proceed to
Step.5
.
5.
Adjust fence until it is flush against combination
square, then tighten 90º set screw on fence slide
bracket until it contacts stop block (see
Figure.40
).
Checking/Adjusting.Fence.
Positive.Stops
90º Set
Screw
Stop
Block