Shop fox W1876, Руководство пользователя

Страница: 34 / 52

Figure.27. Cutterhead area cleaned.
Figure.28.
Cutterhead insert and Torx
screw.
-32-
Model W1876 (For Machines Mfd. Since 7/20)
SE
RV
IC
E
4.
Carefully clean away all sawdust or debris from top
of insert, Torx screw, and surrounding area (see
Figure.27
).
5.
Remove Torx screw and insert (see
Figure.28
), then
carefully clean away all dust and debris from insert
and insert surface on cutterhead.
IMPORTANT:
This step is critical for achieving a
smooth finish with cutting operations. Dirt or dust
trapped under insert during installation will slightly
raise insert in cutterhead, which will leave marks on
workpiece after jointing.
Tip:
Use low-pressure compressed air or a vacuum
nozzle to clean cutterhead surface .
6. Re-install insert with a sharp cutting edge facing
outward. Make sure insert is properly seated on
cutterhead before securing.
— If both insert cutting edges have been used,
replace insert with a new one. Always position
reference dot in same position when installing a
new insert to aid in rotational sequencing.
7.
Lubricate Torx screw threads with a small amount of
light machine oil, wipe excess off, and torque screw
to 48–50 inch/pounds.
IMPORTANT:
If too much oil is applied to the
threads, excess will attempt to squeeze out of
threaded hole as you install insert and force it to
raise slightly, making it out of alignment.
8.. Install cutterhead guard removed in Step.2 .
Torx
Screw
Cutterhead
Insert