Shinko ACD-13A, Инструкция по эксплуатации

Страница: 20 / 132

- 20 -
5. Outline of Key Operation and Setting Groups
There are 2 setting methods for this controller; Simplified setting (traditional setting method),
Group selection. For each setting method, refer to page 21 and subsequent pages.
POWER ON (*1)
(*1)
PV/SV Display Mode
Standby mode
Manual control (*3)
SV
setting mode
Event
setting mode
PID
setting mode
MV /
Remaining step time
indication mode
Each setting item Each setting item Each setting item
SV, Event
group (*4)
Each setting item
( : Goes to the next item. : Returns to the previous item.)
PID group Each setting item
(Operation is the same as the above.)
AT group Each setting item
(Operation is the same as the above.)
To 2
Engineering
group
Input group Each setting item
(Same as the above)
Output group Each setting item
(Same as the above)
Event input group (*5) Each setting item
(Same as the above)
Event output group Each setting item
(*5)
(Same as the above)
Program group Each setting item
(Same as the above)
Communication group
(*5)
Each setting item
(Same as the above)
External setting group
(*5)
Each setting item
(Same as the above)
Transmission output
group (*5)
Each setting item
(Same as the above)
Other function group Each setting item
(Same as the above)
From
2
Simplified setting
Group selection
(3 sec)
+
(*2)
(1sec)
+
(3 sec)
(1sec)
(1sec)
(1sec)
(1sec)
(1sec)
(1sec)
(1sec)
(1sec)
(1sec)
(1sec)
(1sec)
(1sec)
• If the Mode key is pressed for
3 seconds at any setting mode,
the unit reverts to PV/SV
Display Mode.
(*1) The unit starts from the
power-off status.
(*2) For fixed value control, if this
key is pressed for 1 second,
PV/SV Display Mode and
standby mode can be switched.
For program control, this key
runs/stops the control.
(*3) If power is turned off during
manual control, the unit starts
from PV/SV Display Mode.
Setting with Group selection
method is possible during the
manual control. After settings
are complete, the unit starts
from the manual control.
(*4) During program control, this
will be program pattern group.
(*5) If option is not ordered,
relevant setting groups will not
be displayed.
From
1
(1sec)
To
1