48
13. Enhancing Productivity
Read Chapter 7 Before Use of
These Pages
13.2 Piece Counting (PCS)
1
Set up the PCS with menu item
if it is not
set.
(The PCS unit is set before shipment.)
2
Press the
[UNIT]
key several times in the mass
display until the PCS is displayed.
3
Load the container and press the
[O/T]
key to
tare the balance.
4
Count exactly five pieces (or 10, 20, 50, 100, or
200 pieces) of sample to be measured and load
them on the pan.
5
Press the
[CAL]
key.
6
Every time the
[CAL]
key is pressed, the dis-
play sequentially changes as
“Ld 5pcs” ....“Ld 200pcs”, “Ld 5pcs”...
The default setting is “Ld 10pcs”.
Press the
[O/T]
key when the display is equiva-
lent to the number of loaded pieces.
Example
:If 50 pieces are loaded, press the
[O/T]
key when “Ld 50pcs” is displayed. This
determines the unit weight or average
weight per piece.
As sample is added or removed, the
piece count (number of pieces) is dis-
played.
57
(Example)
Note
Repeat steps 3 through 6 above when the sample or manufacturing lot is
changed.
Piece Count Menu Display at Next Setting
In this example, when the
[CAL]
key is pressed in the next PCS menu, dis-
play starts from “Ld 50pcs”.
