Car security systems
53
53
53
53
Setting
Setting
Setting
Setting the
the
the
the basic
basic
basic
basic component
component
component
component of
of
of
of system
system
system
system
Basic
Basic
Basic
Basic block
block
block
block (module
(module
(module
(module of
of
of
of control)
control)
control)
control)
Choose place in passenger cabin for installation of basic block of system (behind the instrument panel of car) and fix the
block by means of two screws.
Also basic block of system may be fixed by means of cable strainer.
Never set basic block of system in compartment of engine of the car, because body of that module is not pressurized. Also
should avoid the installation of that block directly to rated electronic component of the car.
Electronic components of
the car may serve as the resource of radio frequency, in turn, may go to curtailment of working distance of transmitter of
system or appearance of cessation in working system.
Siren
Siren
Siren
Siren
For installation of siren choose place in compartment of engine, in which siren will be protected from access of side end
or arch of front wheel of the car.
In chosen place of compartment of engine for installation of siren may not hot or
moving accessories.
Siren must be sent downwards, and in order to avoid accumulation to its water, faucet must be sent
from compartment of engine outward for maximal spreading sound.
Fix the siren in chosen place on special bracket by
means of screws.
Terminal
Terminal
Terminal
Terminal switch
switch
switch
switch of
of
of
of bonnet
bonnet
bonnet
bonnet or
or
or
or carrier
carrier
carrier
carrier
Terminal switch which incoming to a set of that system, which is preassigned for protective area of carrier (back door in
the car with bodywork “хетчбек” or “all-purpose”) or bonnet of the car.
In any event terminal switch must be fixed in
metallic surface, electrically connected from “mass” the car.
Very importantly install terminal switch in that place, in
which do not leak or the water is not gathered.
Also never install terminal switch in drainpipe, which is positioned in
sides of the car along the bonnet and carrier.
For installation of terminal switch choose the place, which protected by
rubber sealer at closed bonnet or cover of carrier.
Terminal switch may be installed by means of incoming to a set of
bracket or directly to hole by diameter 6 mm (1/4 inch), drilled in bodywork of the car.
In any event of terminal switch
must be installed thus, for the bonnet or cover of carrier at closing pressed terminal switch and displaced its moving
contact not less than 6 mm, at opening permitted to rise moving contact absolutely.
LED
LED
LED
LED indicator
indicator
indicator
indicator of
of
of
of system
system
system
system
LED indicator is positioned in antenna module and consists of two LED.
LED indicator permits to evaluate the
condition of protective system and is visual warning for potential robbers and hijackers.
As a matter of course antenna
module is installed in any glass of the car in which it will be seen well so as from drivers` seat that from outside over glass
of the car.
