ShenZhen YH Innovative Technology, Inc.
30
30
30
30
Programmable
Programmable
Programmable
Programmable system
system
system
system
Programmable
Programmable
Programmable
Programmable personal
personal
personal
personal code
code
code
code of
of
of
of disconnection
disconnection
disconnection
disconnection of
of
of
of system
system
system
system
Function F13 must correspond to condition “secret code”.
Factory code of disconnection of system – 11.
For programming of your personal code enter active personal code for permission of operation of exchange of secret
code:
1.
Divest system out of security (turn off the ignition, if it was turned on and wait for 5 seconds).
2.
Turn on, turn off and afterwards again turn of ignition on.
3.
During 10 seconds press button switch “Valet” of amount of time which corresponds to first number of YOUR
personal code (factory installation – 1 time).
4.
Turn off and again turn of ignition on.
5.
During 10 seconds press button switch “Valet” of amount of time which corresponds to second number of YOUR
personal code (factory installation – 1 time).
6.
Turn off and again turn of ignition on.
7.
If entered code is right, it sounds one short signal of siren.
8.
During 5 seconds turn of ignition off and immediately accomplish procedure of record of new secret code.
9.
Press button switch “Valet” 5 times.
You can hear one short and one long signal of siren which confirming that
system prepares for program of new personal code.
10. During 5 seconds after signals of siren press the button 1 (see picture 1) of transmitter for beginning input of first
number of personal code.
You can hear one confirmative signal of siren.
11. During 10 seconds press the button switch “Valet” of amount of time which corresponding to first number of YOUR
personal code (from 1 to 9).
Siren gives corresponding number of signals which confirming input of first number
code.
12. During 10 seconds press the button 2 of transmitter (see picture 1) for beginning input of second number of personal
code.
You can hear two confirming signals of siren.
13. During 10 seconds press the button switch “Valet” of amount of time which corresponding to second number of
YOUR personal code (from 1 to 9).
Siren gives corresponding number of signals which confirming input of
second number of code.
14. Turn of ignition on.
You can hear one short and one long signals of siren which confirming that the program of new
personal code is completed.
Necessarily record or well memorize Your personal code.
Pay attention to that if function F13 is programmed as “secret
code”, personal code also will be necessary for disconnected function “Anti-Hi-Jack”.
Remark
Remark
Remark
Remark
If system does not confirm input of secret code by audio signal, deliver system to security by means of trinket-transmitter,
afterwards divest system out of security and repeat the procedure of inputting the secret code.
Programmable
Programmable
Programmable
Programmable code
code
code
code of
of
of
of new
new
new
new transmitters
transmitters
transmitters
transmitters
(of
(of
(of
(of anti-hijack
anti-hijack
anti-hijack
anti-hijack transponder)
transponder)
transponder)
transponder)
Important!
Important!
Important!
Important!
Pay attention to that at program of new transmitter to memory of system earlier all programmable codes of transmitter
