ShenZhen YH Innovative Technology, Inc.
28
28
28
28
For delivery of controlling signal to supplementary equipment by channel CH3 use trinket-transmitter according to table
1, table 2 command of control over system, also use the table of programmable functions for choice of asking parameters.
Output of channel CH3 is connected to “mass” during time of active channel. Output of channel CH3 – weak current
output, which is preassigned for control over winding of supplementary relay or equivalent weak current loading.
Remark
Remark
Remark
Remark
If outputs of channel CH2, CH3 were activated at the time, when system was in security condition, and system
momentarily to certain time disconnects sensor of hit and trigger of bonnet/carrier for that opening of carrier did not call
the start of system.
After that carrier will be closed, system again automatically takes this chain under the security.
Remote
Remote
Remote
Remote control
control
control
control over
over
over
over supplementary
supplementary
supplementary
supplementary equipments
equipments
equipments
equipments (channel
(channel
(channel
(channel CH4)
CH4)
CH4)
CH4)
The system has channel CH4 (green wire with black) of control over different supplementary equipments, which are
connected to system.
The channel may be used for:
�
Of remote control over timer equipment;
�
Of pulsed output of negative polarity to 1/12/30 seconds at setting of security system (edition of use – output of
control over window lift, electric hatch and so on);
�
Control over supplementary equipment of alarm signal device – pager.
Output of channel CH4 is connected with “mass” during time of active channel.
Output of channel CH4 – weak current
output is preassigned to control over winding of supplementary relay or equivalent weak current loading.
Remote
Remote
Remote
Remote control
control
control
control over
over
over
over supplementary
supplementary
supplementary
supplementary equipments
equipments
equipments
equipments (channel
(channel
(channel
(channel CH5)
CH5)
CH5)
CH5)
The system has channel CH5 (of blue wire with red strip and blue with black strip) of control over different
supplementary equipments, which are connected to system in condition of start of car engine.
This channel may be used
as:
�
Pulsed outlet with programmable length of opening of lock of passengers` doors at sequential condition of control
over central lock (pulse appears at iterative pressing the button of trinket – “divest out of security” after turning of
condition “security” off).
Length of pulse corresponds to value which is determined in function F7.
�
Pulsed outlet to 20 seconds at dismounting from system out of security (edition of utilization – outlet of control over
polite backlight).
Turning of ignition on abolishes action of pulse at any time.
�
1 second of pulse outlet which arising before automatic start of engine under control over system ZX-1060.
�
1 second of pulse outlet of polarity which arising at turning of line of on in condition of automatic start of engine
under control over system ZX-1060.
Outlet of channel CH5 – three outlets of disconnection relay with current of loading do not more than 25 A in pulsed
condition of control normally.
Remote
Remote
Remote
Remote control
control
control
control over
over
over
over siren
siren
siren
siren
(turning
(turning
(turning
(turning on/turning
on/turning
on/turning
on/turning off,
off,
off,
off, night
night
night
night condition
condition
condition
condition of
of
of
of working
working
working
working system)
system)
system)
system)
If condition of operation of system demands the observance of silence or delivery of alarm signals with the help of
another supplementary equipment (pager). YOU can disconnect audio alarm signal device temporarily absolutely in
security condition.
Light alarm signal device and signal of supplementary channel store its work.
Two momentary
