Car security systems
43
43
43
43
input to condition of program.
5.
During 10 seconds transfer the switch “AST” to condition “ON”.
At this point of time during 1 minute
conversion of the switch to condition “OFF” makes reading and record to memory of actual turnovers of the
engine.
One flash of dimension lights and one long signal of siren will confirm successful record of the turnovers.
If it is
impossible account the turnovers of the engine or accounted turnovers will leave for the border of permitted extent,
and then dimension lights blink three times, siren gives three short signals.
Repeat the process of programmable
signal of tachometer.
In the event of systematical failure, it is possible; have to refuse to use the tachometer.
Programmable signal of
tachometer is preserved in memory of the equipment and temporarily disconnects the delivery.
Check
Check
Check
Check the
the
the
the starting
starting
starting
starting engine
engine
engine
engine by
by
by
by signal
signal
signal
signal of
of
of
of charging
charging
charging
charging batteries
batteries
batteries
batteries (function
(function
(function
(function SF7.2)
SF7.2)
SF7.2)
SF7.2)
If the signal of the tachometer may not be used, program the function SF7.2 of start of the engine by signal of
charging batteries.
System accounts the started engine, if voltage of side network was enlarged more than 0.6V.
Attention!
Attention!
Attention!
Attention!
For some kind of the cars (for example, some cars “Ford”) increase of voltage of charging may happen very slowly
(10 seconds and more) at started engine.
Necessarily study the condition of working charging batteries in your car
for right choice of time of rolling starter in function SF9.
In the event of that it commends to choose fixed times
of starter – 0.6 second, 0.8 second, 1 second, 1.5 second or 2 seconds.
System continues every time automatically to check the line of charging batteries during 1 minute after stopping
the starter.
If voltage of charging does not exceed 0.6 V, ZX-1060 accomplishes following attempt of start over 1
minute.
Check
Check
Check
Check the
the
the
the starting
starting
starting
starting engine
engine
engine
engine by
by
by
by signal
signal
signal
signal of
of
of
of working
working
working
working generator
generator
generator
generator (function
(function
(function
(function SF7.3)
SF7.3)
SF7.3)
SF7.3)
If the signal of tachometer may not be used or you are not convinced of working system of charging batteries,
program the function SF7.3 of starting engine by signal of working generator of the car.
System considers the
started engine, if voltage in line of excitation winding of generator achieved 12 V and more.
At accomplishment
of starting engine the system checks voltage always in line of excitation and in the event of disconnectation does
not permit to start the engine in condition of the car.
For more accurate definition of moment of starting engine
(in order that do not twist starter of the car) use the table of values of voltage of side chain, more it’s the engine is
considered by winding.
Outside additional resistor is turned on by resistance 0-56 kilohm consecutively to line of
wire the input TACH (green wire with orange (brown) strip).
R
additional
-
additional
resistor
Immediate
input
Tach
(loop
of
yellow wire is not
cut)
Loop of yellow
wire is cut
Loop of yellow
wire is cut and
supplementary
resistor
27
kilohm
Loop of yellow
wire is cut and
supplementary
resistor
47
kilohm
Loop of yellow
wire is cut and
supplementary
resistor
56
kilohm
Threshold
of
definition
of
starting
engine
(volt)
3.5
5.1
8
10.2
11
