SHERCO 250 SEF RACING, Руководство пользователя

Страница: 133 / 306

133
FRANÇAIS
ENGLISH
ESP
AÑOL
DEUTSCH
ELECTRICAL SYSTEM MAINTENANCE
The headlight beam is adjusted with the motorcycle
in a state of operation with its driver seated on the
saddle.
To set the headlight beam, tighten or loosen the
screw at the base of the headlight housing.
Tightening the screw raises the headlight beam.
Loosening the screw lowers the headlight beam.
1. Remove the headlight housing (

p.131).
2. Remove the turn signal flasher in order to access
the motorcyle computer screws.
3. Remove the screws and remove the computer
to get it out of the way.
4. Disconnect the main connector from the computer.
5. Open the dashbord with a coin.
6. Install a new battery (with the marking up).
7. Replace the cover, taking care not to damage the
O-ring.
8. Plug the main connector into the computer.
9. Install it on the bike and check to make sure the
meter works.
10. Reinstall the computer support.
11. Install screws and replace the turn signal flasher.
12. Replace the headlight housing (

p.132).
13. Set the computer (

p.95).
ADJUSTING THE HEADLIGHT BEAM
REPLACING THE MOTORCYCLE COMPUTER BATTERY
1
2
2
Computer battery CR 2032 3V
1
1
1
1
1
2