20
ENGLISH
USING YOUR SETO POWER LED
The SETO POWER LED can be set up in two basic modes. Torch mode allows the user to carry the unit with the
extension arm and head folded down and locked in position.
Worklight Mode
Worklight mode allows the user to site the unit in a suitable position on the ground or on a platform where the
extension arm can be swung up and locked into position. The height of the extension arm can then be adjusted
by lifting up the locking lever on the extension arm clamp and moving the light head up or down to the desired
position. The locking lever can then be clicked back in to place to hold the position. The light head can then be
turned in either direction and the angle can be adjusted using the clamping handle. The button on the clamping
handle allows the user to park the handle at a particular point, this may be useful to increase or decrease the
frictional force applied to the light head when held in postion.
Twin sockets – either socket can be used to charge and/or run the SETO POWER LED light. In addition the light
heads can be run simultaneously, or additional 12V equipment such as a phone charger can be powered.
To use your SETO POWER LED make sure the plug from the light head is inserted into either of the two sockets
on the battery unit, the red locking ring on the plug can then be turned clockwise to prevent the plug from being
accidentally pulled out.
Your SETO POWER LED is designed to work in a harsh environment from low to high temperatures. While high
temperatures can have an adverse effect on LEDs this unit has been designed to counteract this if ever the situa-
tion arose. A temperature sensor monitors the LED light engine output and adjusts the power output accordingly,
but still maintains a slightly reduced light output.
Torch Mode
