17
ENGLISH
Remote Control System
The optional remote control system allows complete control of brightness, modes
and battery status allowing the unit to be placed out of reach yet with full control
at your fingertips. In addition any number of extra SETO POWER LED units can be
automatically switched on and controlled by the one remote through the mesh net-
working technology employed. One button press can switch on over a hundred units
instantly, each unit allows the signal to be rebroadcast, so infinite distances and areas
can be covered.
Emergency System
Using the same technology as that employed in the remote control system the op-
tional emergency system can be configured to detect a failure in a building or site
voltage supply (permanent mains or generator) and automatically signal any number
of SETO POWER LED units to switch on and provide a wireless emergency lighting
system adding new levels of safety and convenience of the work environment.
On board charging
An optional built in charging system can be added to allow fully automatic charging
from any 12 or 24V vehicle. A single multi-colour LED gives full indication of the char-
ge process. In addition the charger benefits from a vehicle battery protect mode to
prevent over discharge of the vehicles primary battery.
The in-built charger has a temperature monitor to accurately measure and control
the charge to the high performance cyclic battery. This means that whether the unit is
charged in a hot or cold environment the battery is always charged to 100% to stop
the reduced effects on performance associated with less advanced charging systems.
Construction
The SETO POWER LED has been constructed using high quality materials to produce
a tough, long lasting product for the professional user.
Operation - Quick Start
Although the SETO POWER LED is full of features it is still simple to use. When the
unit is packed down in torch/storage mode the on/off switch is recessed to prevent
accidental switch on, yet is still accessible to the user when needed.
Press once to switch on and again for off. Whenever the unit is first switched on it will
default to the 100% brightness setting regardless of how the unit was last used. At
switch on you will hear a bleep from the unit to signal all is well, the battery status LED,
near to the on/off switch, will illuminate to show the units state of charge.
Always remember to put your SETO POWER LED on charge after use to prolong
the life of the high capacity rechargeable battery.
