2-38
Setting media advance correction values
The factors that change the media advance correction values are as follows.
Change of print mode
Pressure change using the pressure control knob
Use/not use of take-up reel unit
Type of media
Difference in media feed route
–
•
•
•
•
•
1
Set media longer than 4 m.
Obtain the rough media advance correction value in [ROUGH] and determine
the media advance correction value in [DETAIL]. Both [ROUGH] print and [DETAIL]
print need paper of about 90 cm in length for one-time print. (To cancel printing
of media advance correction pattern, press the
CANCEL
key.
2
Set the printer to the offline mode.
(Press the
O N L I N E
key.)
I N K M E D I A R E G
M E D I A M . A D V
3
Press the
key and then
key to display the media advance
correction pattern.
# M E D I A A D V P R I N T
> R O U G H ( N O R M A L 1 )
Select the print mode to be used normally for the media to set the media
advance correction value.
(For details of print mode, refer to
P.4-2 [Print mode]
.)
Note
To obtain the media advance correction value in DENSITY2 mode, apply the
media advance correction patterns, ROUGH(QUALITY) or DETAIL(QUALITY).
–
4
Select the rough print mode with
the
and
keys, and press
the
key.
# M E D I A A D V P R I N T
* O K ?
