2-27
2
Basic oper
a
tion
Media installation and removal
NOTE2
When the paper tube's inner diameter is not sufficiently longer than the flange
spacer's diameter, the flange spacer cannot be pushed all the way in the paper
tube, and the gap may be found between the rubber spacer A and the paper tube
edge. In such a case, to clear the gap set the rubber spacer B between the rubber
spacer A and the paper tube.
Rubber Spacer A
Rubber Spacer B
–
11
Attach the media to the paper tube.
Confirm that the media is wound in outer-side take-up mode. With adhesive
tape, hold the media straight at the center, and then at the rest positions in the
direction from the media center to the media edge.
NOTE
Ensure that the media is attached with no slant nor slack which will cause
the slanting feed.
–
12
Feed the media with the operation panel's FEED menu, and take
up the media on the paper tube for one turn or more.
13
Check the paper tube flanges' position, and adjust it if necessary.
14
With the panel operation, set the printer to online.
