2-92
Print out the edge sensor adjustment pattern, and correct the edge sensor position.
After printing, measure the distance and specify the parameter.
1
Hold down the
M E N U
key until
the [ADJUST] menu appears.
P R I N T E R S E T U P
A D J U S T H E A T E R
2
Press the
key to enter the
[ADJUST] menu.
# T E S T P R I N T S
> N O Z Z L E P R I N T
3
Press the
key.
4
Hold down the
key until the
[ C H E C K E D G E S E N S O R ] m e n u
appears.
# T E S T P R I N T S
> C H E C K E D G E S E N S O R
5
Press the
key.
# T E S T P R I N T S
* O K ?
6
Press the
key.
# T E S T P R I N T S
* E X E C U T I N G
7
Judge the printing results.
Measure the margin of the printing result
with a square, and obtain an difference
between the measured margin and the
value (15 mm) shown in the specifi cations.
If the difference is 15 mm, complate this
procedure.
If not, follow the prcedure below to correct
the value.
508 nozzles
(Blank by the even
number of heads)
508 nozzles
(All nozzles)
15 mm
Correcting the edge sensor position
