28
|
MAGIQTOUCH & MAGIQCOOL MODELS
2
3
1
ILL1645-A
EXTRA NOTES FOR EZQ MODEL ONLY
Before fitting the 4 main pad frames, make
sure the 3 lower pads are refitted into their
respective positions in the base of the
cooler.
To refit the pad frame, locate the bottom
edge in the tank groove, then push the top
in under the lid. The frame should clip into
the cooler with a firm push of the hand at the
two points where the screwdriver was used.
Remember to insert the corner clips after
replacing the pad frame(s).
BREEZAIR EXQ / EZQ / EXS
EVAPORATIVE COOLER
cont
ILL1600-A
2
3
1
REFITTING THE PAD FRAMES
Refit the pad frames by locating the bottom
edge in the tank groove, then push the top in
under the lid.
Refit the corner clips after replacing the pad
frame(s).
When re-fitting pads, ensure that they are
fitted in their original positions.
EXQ210,
EZQ215 and all EXS model coolers have pads
that vary from the standard 90mm thickness.
While removing the pad frames, take note of
the location each belongs to.
Check for stickers indicating correct
locations for thick or cut edge pads.
ILL1894-A
Stickers adhered to the fan scroll indicate the
correct position.
If fitted incorrectly they may cause
problems:
• Thicker pads may catch on internal components
causing damage.
• Thicker pads may impede the correct operation of
the float valve.
• Incorrect positioning of pads may cause a drop in
cooler performance.
•
Incorrect fitment may allow water to bypass the
pad and be carried over into the air stream and
ducting.
• Water bypass may cause damage to internal
electronic components.
