Security Command Executive series, Руководство пользователя

Страница: 16 / 40

13
User Menu
User Menu
Security Command User Menu
Many of the features of your system have been put into a User Menu
you can access from any Security Command keypad. The menu
requires you to enter your security code and then only shows those
functions to which you have access.
To access the User Menu:
1. Press the COMMAND key until MENU? NO YES displays.
2. Select YES. The keypad displays ENTER CODE: –. Enter your
security code and press COMMAND. You can now scroll down
through the list of system features available to your authority level.
The following pages detail each user menu item and provide
instructions on when and how to use them properly. The User Code
Level reflects the
minimum authority level required.
Alarm Silence
User Code Level: 3 and above.
Function: Silences the alarm bell or siren during an alarm.
Alarm Silence allows you to turn off the alarm bell or siren connected
to your system during an alarm. Using Alarm Silence does NOT stop
an alarm report from being sent to the central station and does not
reset any alarmed devices. Use the Sensor Reset function to reset
devices such as smoke detectors that have latched in alarm.
Note: You can also silence an alarm by entering your security code
and pressing COMMAND while the bell or siren is still sounding.
Using the Alarm Silence Function
1. Access the User Menu.
2. The keypad displays ALARM SILENCE?.
3. Press any SELECT key. The system silences the bell or siren
and returns the keypad to the status display.
Sensor Reset
User Code Level: 1 and 2 - During schedules only. 3 to 9 - Anytime.
Function: Resets smoke or glassbreak detectors. Also clears Fire/
Supervisory alarm and trouble displays.
Sensor Reset is used to reset smoke and glassbreak detectors after
they have been tripped. Once these detectors have tripped, they
must be reset before they can detect any additional alarm conditions.
When Sensor Reset is selected, power to the detectors is temporarily
removed by the system allowing them to reset.
Make sure all smoke is cleared from around the area of the smoke
detectors before performing a Sensor Reset to prevent the alarm
from occurring again.
Resetting the Sensors
1. Access the User Menu.
2. Press the COMMAND key until SENSOR RESET? is displayed.
3. Press any SELECT key. The keypad displays SENSORS OFF
for five seconds followed by SENSORS ON.
4. The keypad returns to the status display.