Security Command Executive series, Руководство пользователя

Страница: 14 / 40

11
Home/Away System Arming
Area Assignment: Your security system is divided into two or three
separate areas. Motion detectors, inside doors, and other interior
devices are assigned to an
Interior and possibly Bedroom area while
windows and exterior doors, are assigned to a Perimeter area.
Arming the system: When arming a Home/Away system, the
keypad displays HOME AWAY or HOME SLEEP AWAY. If you
select AWAY, you arm all areas of the system. You’ll want to arm all
areas when leaving with nobody staying inside. Selecting HOME
arms only the Perimeter of the system. Perimeter arming is for when
you’re staying inside but want the comfort of knowing the exterior
doors and windows are armed. Perimeter arming allows you to move
freely about inside without setting off any interior alarms.
Selecting SLEEP arms the Perimeter and Interior devices but leaves
devices near bedrooms or other nighttime areas off.
System Ready/System Not Ready Keypad Displays
When all loops in the system are in a normal condition and can be
armed without bypassing, the keypad displays SYSTEM READY. If
there are one or more loops that are not in a normal condition, the
keypad displays SYSTEM NOT READY. Pressing any top row
SELECT key during this display shows the loop number and name
allowing you to investigate the problem.
Arming a Home/Away System
1. Enter a 1 to 3 digit code and press the COMMAND key or enter
a 4 digit code without pressing the COMMAND key. The keypad
displays HOME AWAY or HOME SLEEP AWAY (your system
may have two
or three areas.
2. Select HOME to arm the Perimeter only.
3. Select SLEEP to arm the Perimeter and Interior.
4. Select AWAY to arm the Perimeter, Interior, and Bedroom.
5. The Security Command displays loops that have been bypassed
prior to arming and 24 hour loops that are in a bad condition. No
action is required by you.
6. Bypass any bad loops if required. See steps 6a through 6c.
6a. If a problem exists on one or more loops, the loop name and
problem is displayed followed by BYPASS? NO YES.
6b. Select NO to stop the arming sequence without bypassing
any loops. Correct the problem and return to step 1.
6c. Select YES to bypass all bad non-24 hour loops.
7. The Security Command displays PERIMETER ON if you selected
HOME, PERIM/INT ON if you selected SLEEP, and ALL SYSTEM
ON if you selected AWAY. The system then arms all non-exit
loops.
8. The Security Command next displays EXIT: ## INSTNT and
begins to count down the number of seconds remaining for you
to exit. When the delay expires, the exit loops are armed.
9. You can select INSTNT while EXIT: ## INSTNT is displayed to
immediately arm all exit loops and make them instant. The
keypad displays INSTANT.
10. When the system is fully armed, the keypad displays PERIMETER
ON for Perimeter arming, PERIM/INT ON for Perimeter and
Interior arming, and ALL SYSTEM ON for all areas armed.
Arming and Disarming