Security Command Executive series, Руководство пользователя

Страница: 25 / 40

22
Schedules
User Code Level: 7 and above
Function: The Schedules function allows you to program into the
system the times at which you normally turn your burglary protection
on and off each day of the week. This information can then used by
the system to automatically arm or disarm the burglary protection.
If your system does not use automatic arming, you can use the
Closing Check/Extend feature with Schedules to help ensure your
system is armed manually at a specific time. This option sounds the
keypad buzzer and displays CLOSING TIME! when a schedule
expires. Users still on the premises are reminded to arm the system
or extend the schedule to a later time. If the system is not armed, or
the schedule extended, a report can be sent to the central station.
Schedules can also be used to restrict access to the system by users
with a 1 or 2 authority level assigned to their codes.
Your system provides you with three different types of schedules:
Permanent, Primary, and Secondary schedules occur at the
same programmed time until you change or delete them. These
are typically used for automatic arming and/or disarming.
Temporary schedules occur only once and then cleared from
the system. These are typically used to allow someone one time
access to the premises when used with a level 1 or 2 code.
Output schedules allow you to set the times when relay outputs
connected to your system are turned on and off automatically.
There is one set of schedules for each area for each day of the week.
Refer to System Setup to see how your system is programmed.
Setting an Arming and Disarming Schedule
1. Access the User Menu.
2. Press the COMMAND key until SCHEDULES? displays. Press
any SELECT key.
3. The keypad displays PRM TMP OUT (or PRI SEC OUT). Press
the SELECT key under PRM (or PRI). This will enter a schedule
that remains in place until you change or delete it.
4. The keypad displays SUN MON TUE WED. Press the COMMAND
key to display THU FRI SAT. Press the SELECT key under your
choice.
Note: After selecting the day of the week for the schedule to occur,
the keypad displays any currently programmed Opening and
Closing times previously set for that day. This feature allows you
to review programmed schedules at any time.
5. If Opening and Closing times are displayed, the keypad then
displays DELETE KEEP. Press the SELECT key under
DELETE to enter new times.
6. The keypad then displays OPENING TIME? followed by the
display – : AM PM. Enter the new opening time and select
AM or PM.
The keypad then displays CLOSE TIME? followed by the display
– : AM PM. Enter the new closing time and select AM or PM.
Enter all schedule times using a 12 hour clock. For example, to
enter 6 am you would enter a 0 + 6 + 0 + 0 and press the SELECT
key under AM. For 11 pm you would enter a 1 + 1 + 0 + 0 and
press the SELECT key under PM.
User Menu