Security Command Executive series, Руководство пользователя

Страница: 12 / 40

9
All/Perimeter System Arming
Area Assignment: Your security system is divided into two separate
areas. Motion detectors, inside doors, and other interior protection
devices are assigned to the
Interior area while windows and exterior
doors are assigned to the Perimeter area.
Perimeter or All: When you go to arm an All/Perimeter system, the
Security Command keypad displays PERIM ALL. If you select ALL,
you’re arming both the Perimeter and the Interior of the system. You’ll
want to arm both of these areas when leaving the premises with
nobody left inside. Selecting PERIM arms only the perimeter of the
system. Perimeter arming is for when you’re staying inside but want
the comfort of knowing the exterior doors and windows are armed.
Perimeter arming allows you to move freely about inside without
setting off any interior alarms.
Instant: During the exit delay time, you can cancel the exit and entry
delays and cause all loops to be instant loops. Just press the far right
select key under INSTNT while the exit delay is displayed. This
immediately arms the exit loops. However, no entry delay is provided
and an alarm will occur should an entry door be opened.
Arming an All/Perimeter System
1. Press the COMMAND key until PERIM ALL is displayed.
2. Select ALL to arm both the perimeter and interior areas. Press
PERIM to arm the perimeter area only.
3. Enter your code number if required.
4. The Security Command displays loops that have been bypassed
prior to arming and 24 hour loops that are in a bad condition. No
action is required by you.
5. Bypass any bad loops if required. See steps 5a through 5c.
5a. If a problem exists on one or more loops, the loop name and
problem is displayed followed by BYPASS? NO YES.
5b. Select NO to stop the arming without bypassing any loops.
Correct the problem on the loop and return to step 1.
5c. Select YES to bypass all bad non-24 hour loops.
6. The Security Command displays PERIMETER ON if only the
perimeter is being armed and ALL SYSTEM ON if both the
perimeter and interior are being armed. The system then arms all
non-exit loops.
7. The Security Command next displays EXIT: ## INSTNT and
begins to count down the number of seconds remaining for you
to exit. When the delay expires, the exit loops are armed.
8. You can select INSTNT while EXIT: ## INSTNT is displayed to
immediately arm all exit loops and make them instant. The
keypad displays INSTANT.
9. When the system is fully armed, the keypad displays PERIMETER
ON for perimeter arming and SYSTEM ON for perimeter and
interior arming.
Arming and Disarming