Sea Recovery SRC Aqua Matic 1400-2, Руководство пользователя

Страница: 24 / 223

• It will be the Installer's liability, if he/she did not notify the System Owner.
• It will be the System Owner's liability if the Installer properly notified he/she that the RO Membrane Element(s)
were not installed and to not operate the system without the RO Membrane Element(s) installed.
Component Descriptions
All components supplied by Sea Recovery Corporation (both standard and optional) are described in this section,
along with items required or optionally supplied by the Installer. The location, operation and purpose of each major
component are briefly explained in this section. Remember, the major documented cause of failures and problems
are from the use of third-party, non-Sea Recovery parts; improper installation; and improper operation. Do not
use parts, components from any source other than Sea Recovery! Sea Recovery Corporation maintains
inventory for immediate shipment and our Service Dealers throughout the world maintain stock of Sea Recovery
parts. Always insist on Sea Recovery supplied parts in order to avoid failures, eliminate problems, and maintain
your warranty. The use of third-party, non-Sea Recovery components, spares and assemblies will result in the
following:
• Damage to the Aqua Matic RO Desalination System and/or damage to specific components within the System.
• Voiding the Aqua Matic RO Desalination System's warranty and/or voiding the affected System component's
warranty.
Pre-filtration Components
The Pre-filtration section of your Aqua Matic RO Desalination System filters and delivers feed water. The raw feed
water is filtered to remove suspended solids larger than 5 Microns (5/1,000,000 of a meter). Pre-filtration protects
the High Pressure Pump from premature wear, and the Reverse Osmosis Membrane Element from premature
fouling.
1. Inlet Thru Hull Fitting with Forward Facing Scoop
The point at which the Feed Water enters the system. The System's Installer must use a forward-facing scoop
so that the System receives positive water flow as the ship is moving.
Caution: A flush Inlet Thru-hull Fitting will create a vacuum as the ship is moving, thus causing loss of
Feed Water flow and cavitation of the Booster and High Pressure Pump. This will result in continuous
system shut down.
Caution: The Installer must utilize a forward-facing scoop, so that the system receives positive water
flow when the ship is moving. The fitting must be installed on the ship's hull, in a position that provides a
continuous, air-free supply of Feed Water.
Caution: The resulting failure of the System to remain in operation is attributed to improper installation.
Thus, it is the Installer's liability, and will not be not covered by the Sea Recovery Corporation warranty.
2. Sea Cock Valve
Used (for safety reasons) to close the Feed Water line during repair, maintenance and disuse of the system.
3. Sea Strainer
Filters out large particulate matter and suspended particles that would otherwise damage the Booster Pump
and prematurely foul the cartridge Pre-filter Element. The Sea Strainer has a clear bowl with a bronze body
filter housing, that contains a cleanable, monel filter screen.
4. Booster Pump
Supplies positive pressure to the Pre-filters and onward to the High Pressure Pump. The Booster Pump has a
performance curve of 85 Feet Head or 35 PSI (2.41 BAR) @ 60 Hz with a Feed Water flow of 4.5 GPM (17
LPM). The resulting pressure at the High Pressure Pump depends on the final installation configuration and
condition of the Pre-filtration elements.
5. Low Pressure Transducer #1
Aqua Matic Compact 450-1800 22