Sea Recovery SRC Aqua Matic 1400-2, Руководство пользователя

Страница: 111 / 223

Ultraviolet Sterilizer
The UV Sterilizer lamp emits low frequency light. The light degrades and loses intensity, as well as its ability to
sterilize biological matter over approximately 8000 hours of use. Therefore, the lamp may remain lit, but requires
replacement every 4400 to 8000 hours.
Danger: UV light is harmful to eyes and skin! Check that system power is turned OFF before beginning
sterilizer maintenance.
Lamp Replacement
1. Remove the four screws on the ballast box.
2. Remove lid.
3. Remove rubber boot and carefully pull lamp out of quartz sleeve.
4. Replace the lamp.
Note: During lamp replacement, clean the quartz sleeve as well. The quartz sleeve should be clear. If
discolored, it must be cleaned or replaced.
Quartz Sleeve Cleaning
1. Remove the four screws on the ballast box.
2. Remove lid.
3. Remove rubber boot and carefully pull lamp out of the quartz sleeve.
4. Unscrew and remove two compression nuts (ballast box and view port).
5. Remove the O-ring on the view port side only.
6. Carefully pull the quartz sleeve out from the ballast box side.
7. Clean the quartz tube with water and a bottle brush without moving the O-ring. Dry with a soft cloth. Handle the
quartz sleeve carefully.
Reassembly
1. Replace old O-rings with new O-rings.
2. Insert the quartz sleeve (close-end first) through the ballast box pass thru until O-ring contact pass thru. Screw
on the ballast box compression nut. Insert view port O-ring and screw on view port compression nut.
3. Attach a new UV Lamp into the plug.
4. Slide the lamp into the Quartz Sleeve and install rubber boot over the compression nut.
5. Replace the three ¼-20 cap head screws.
Fresh Water Flush Carbon Filter Element
The Carbon Filter Element in the Fresh Water Flush must be replaced every three months. The Fresh Water Flush
will automatically flush the system with Fresh Water every preset number of days. The duration of the flush cycle
will be 90 seconds for a system connected to 60 Hz power and to 120 seconds for systems connected to 50 Hz
power. To replace the Carbon Filter Element, follow the procedures below.
1. Unscrew the bowl counter-clockwise.
2. Remove the Carbon Filter Element from the bowl.
3. Remove the O-Ring from the top of the bowl.
4. Replace the Carbon Filter Element with a new Sea Recovery Corporation element.
5. Wipe the O-Ring with a damp cloth.
6. Sparingly lubricate the O-Ring lightly with O-Ring lubricant.
7. Place the O-Ring back onto the bowl.
8. Insert the new Sea Recovery Carbon Filter Element into the bowl.
109
Maintenance and Repair