Sea Recovery SRC Aqua Matic 1400-2, Руководство пользователя

Страница: 20 / 223

• The System's Feed Water Sea Cock Valve is closed.
• The System's main electrical disconnect switch is OFF, LOCKED and TAGGED.
Installer Minimum Qualifications
The System's Installer must have technical expertise in the following areas:
• Electrical, Electronic, Electric Motors and Circuits
• Electromechanical and Mechanical Systems
• Hydraulic and Liquid Pressure and Flow Systems
• Piping and Plumbing Systems
• Water Suction and Pressure Lines
• Thru-Hull Fitting below and above water level
Do not attempt maintenance and repair if you are not proficient in the aforementioned fields of expertise.
Warnings
Danger: ELECTRICAL SHOCK HAZARD The Aqua Matic RO Desalination System installation procedures
expose the installer to high voltage and potential electrical hazards. Technicians should only attempt installation
if (1) they are qualified electricians and (2) surrounding conditions are safe.
Caution: Do not attempt Installation, commissioning, troubleshooting, or repair of the unless you are proficient
in the fields/functions listed within the section
Installer Minimum Qualifications on page 18.
Caution: The RO Membrane Element is stored in sodium bisulfite. Avoid skin and eye contact with this
packaging solution. If skin contact occurs, rinse skin thoroughly with water. If eye contact occurs, flush eyes
repeatedly with water and notify a physician immediately.
Caution: Never mount the liquid holding component above any electrical or electronic device. Extensive
damage to the electronic device will result if liquid enters device during maintenance and/or component
failure.
Important: Do not over-tighten PVC fittings. If threaded pipe fittings leak after installation, remove the fitting,
clean the mating threads, apply three (3) to four (4) wraps of Teflon tape to the male threads, apply liquid
Teflon pipe sealer sparingly, and thread the parts back together. PVC fittings should be hand tightened,
without the use of a wrench.
Important: The Sea Cock Valve, Inline Pressure Gauge, Sea Strainer, Rinse Clean Inlet Valve, and Booster
Pump should be installed below water level. This will aid the Booster Pump in priming.
Important: Always allow hoses and tubes to enter and exit straight from the connection for a minimum of 1
in. prior to a bend. If stress is placed on the fitting due to a tight bend, the fitting will leak and may break.
Important: All connection lines should be as short and straight as possible using minimum fittings. Ensure
that they are not “kinked”.
Important: Ensure that the power source is sufficiently sized to provide the correct voltage and cycles during
System start up and operation.
Remember: Install the system and its supporting components in an accessible manner.
Aqua Matic Compact 450-1800 18