Sea Recovery SRC Aqua Matic 1400-2, Руководство пользователя, Страница: 35 / 223

Chapter
4
Installation
Caution: All mounting surfaces must be flat in order to avoid bracket and frame warping. Damage caused by
attaching the System (or its components) to an uneven surface will be attributed to improper installation; is the
liability of the Installer; and is not covered by the Sea Recovery Corporation warranty. Grind mounting surfaces
flat, or use appropriate shims on uneven surfaces, to ensure that System component mounting does not cause
bending or warping.
System Frame
The System frame must be placed in a location that allows the following:
• Safe and convenient operation and maintenance access.
• Sufficient room for Filter Bowl removal.
• Safe and convenient access to the right side of the frame for electrical wire attachment.
• Touch-pad access (i.e., it is both reachable and readable).
Note: The System frame is mounted in-place by four (4) rubber-isolation mounts (supplied). Four (4) threaded
bolts and four (4) sheet-metal screws are provided for attachment.
1. Lay the System frame on a flat surface and mark the mounting holes.
2. Temporarily move the System frame, and drill the appropriate holes (depending on the hardware that you are
using).
3. Place the System frame over the drilled holes and attach the rubber isolation grommet under the frame at each
of the four (4) mounting points.
4. Place the mating, rubber-isolation grommet on top of the frame hole, and attach it with the appropriate supplied
washers, bolts and screws.
Component Mounting
Tube-Fitting Assembly
The following tasks provide guidance on tube-fitting assemblies. A general diagram is displayed below.
Caution: If water lines are pulled tight and, thereby, bent at the fitting, they can leak, allow air to enter, fail
prematurely, and/or break the attached fitting. Always allow slack in tube and hose lines. Never cause a bend
in the tube or hose to at the fitting. The line must enter or leave the fitting in a straight manner for several
33